Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:manual:reference_installation [2023/12/05 09:59] throgh |
en:manual:reference_installation [2024/03/11 19:33] throgh Remove doubled entries |
||
---|---|---|---|
Line 357: | Line 357: | ||
===== Installation ===== | ===== Installation ===== | ||
==== Partition disks ==== | ==== Partition disks ==== | ||
+ | |||
+ | <note important> | ||
+ | These instructions assume that you are using MBR (Master Boot Record) as the partitioning scheme for your installation disk. Installation on a GPT-based disk is slightly different than the process described here. | ||
+ | </ | ||
+ | |||
Once your computer has successfully booted into the Live USB device, type the following into you terminal: | Once your computer has successfully booted into the Live USB device, type the following into you terminal: | ||
Line 390: | Line 395: | ||
<code bash> | <code bash> | ||
# swapon /dev/sda1 | # swapon /dev/sda1 | ||
- | </ | ||
- | |||
- | === Mount the root partition === | ||
- | <code bash> | ||
- | # mount /dev/sda2 /mnt | ||
</ | </ | ||
Line 420: | Line 420: | ||
We now must mount the root partition on <color # | We now must mount the root partition on <color # | ||
+ | === Mount the root partition === | ||
+ | |||
+ | <code bash> | ||
+ | # mount /dev/sda2 /mnt | ||
+ | </ | ||
==== Verification of system-date ==== | ==== Verification of system-date ==== | ||
Line 508: | Line 513: | ||
</ | </ | ||
- | <code bash> | ||
- | # echo myhostname > / | ||
- | </ | ||
- | * Symlink <color # | + | === Locale === |
- | + | ||
- | <code bash> | + | |
- | # ln -s / | + | |
- | </ | + | |
* Set [[en: | * Set [[en: | ||
- | === Locale === | ||
Type: | Type: | ||
Line 634: | Line 631: | ||
Here do NOT append a partition number, i.e. <color # | Here do NOT append a partition number, i.e. <color # | ||
</ | </ | ||
- | |||
- | <code bash> | ||
- | # grub-mkconfig -o / | ||
- | </ | ||
* To configure the bootloader, you have to install it and generate the file <color # | * To configure the bootloader, you have to install it and generate the file <color # | ||
Line 671: | Line 664: | ||
=== Bootloader on external drive === | === Bootloader on external drive === | ||
- | |||
- | <note tip> | ||
- | If you are following the [[en: | ||
- | </ | ||
- | |||
- | -------------- | ||
* Configure the network again for newly installed environment. | * Configure the network again for newly installed environment. |