Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:manual:reference_installation [2024/03/11 19:39] throgh |
en:manual:reference_installation [2024/03/26 23:21] (current) throgh |
||
---|---|---|---|
Line 564: | Line 564: | ||
< | < | ||
- | |||
- | * Uncomment the selected locale in <color # | ||
=== Time zone === | === Time zone === | ||
Line 623: | Line 621: | ||
</ | </ | ||
- | * To configure the bootloader, you have to install it and generate the file <color # | + | To configure the bootloader, you have to install it and generate the file <color # |
<code bash> | <code bash> | ||
Line 629: | Line 627: | ||
</ | </ | ||
- | * For BIOS and EFI: | + | === Syslinux === |
- | <code bash> | + | [[https://en.wikipedia.org/ |
- | # pacstrap | + | |
- | </code> | + | |
- | * Install GRUB after chrooting (refer to the [[en: | ||
- | |||
- | === Syslinux === | ||
<code bash> | <code bash> | ||
# pacstrap /mnt syslinux | # pacstrap /mnt syslinux | ||
</ | </ | ||
- | * Configure <color # | + | For further details refer to the [[https:// |
+ | |||
+ | === Create RAM-disk | ||
+ | |||
+ | Configure <color # | ||
<code bash> | <code bash> | ||
Line 650: | Line 647: | ||
< | < | ||
- | * If you want to install GRUB for the (U)EFI mode, you will need to make sure that: | + | If you want to install GRUB for the (U)EFI mode, you will need to make sure that: |
* The computer booted in (U)EFI mode (if <color # | * The computer booted in (U)EFI mode (if <color # | ||
* The efivars module is loaded. (<color # | * The efivars module is loaded. (<color # | ||
- | |||
- | === Bootloader on external drive === | ||
- | |||
- | * Configure the network again for newly installed environment. | ||
=== Unmount and reboot === | === Unmount and reboot === |